Digital Aquatics Reefkeeper 2 Temperature Malfunction.

[Jasonanatal]

I just purchased two separate Digital Aquatics Reefkeeper 2 Units for my 28 gallon JBJ Nano Cube HQU Reef Aquarium. Just recently one unit started acting up where the Temperature Display is jumping constantly from 0.1 to 0.3 degrees while the second units Temperature display is fine. I switched Temperature Probes to see if it was an issue with the unit or temperature probe but both probes show the Temperature jumping when plugged into the main unit. Does anyone have a solution for this? Thank you.

YouTube - Digital Aquatics Reefkeeper 2 Temperature Malfunction.

Video - Digital Aquatics Reefkeeper 2 Temperature Malfunction.

[Phurst]

I'd check with DA. Their customer service is first rate.

[Jasonanatal]

Originally Posted by Phurst

I'd check with DA. Their customer service is first rate.

Phurst, I actually have sent them an E-mail because I try calling and get nothing but a voicemail. They have a forum dedicated to them on Reef Central which they told me to try a Factory Reset which normally clears up the problem which I did but the issue still seams to be recurring.

[Seahorsedreams]

I bet they're busy as heck because they are about ready to roll out the RKE.

*waits patiently for her's to arrive*

[Jasonanatal]

Originally Posted by Seahorsedreams

I bet they're busy as heck because they are about ready to roll out the RKE.

*waits patiently for her's to arrive*

Seahorsedreams, hopefully since I have been a good boy they will replace my Reefkeeper 2 with a Reefkeeper Elite (Crossing Fingers). LOL