Anyone here have a large hole saw? I need to have some washers of sorts made to cover up some chipped glass around some holes that were drilled in my tank for a closed loop. With out these I do not think there is a safe way to get a seal with the bulk heads.

<CENTER><IMG SRC="http://www.gordonious.com/RC/nuts.bmp">
These would be for two 3/4" bulk heads.

<IMG SRC="http://www.gordonious.com/RC/smallnuts.bmp">
These would be for four 1/2" bulk heads.

<IMG SRC="http://www.gordonious.com/RC/HPIM6850cs.JPG">
And here you can hopefully see why I need them.</CENTER>

Jon

try to fix ur link.. using this"[img]"


hope it helps =]

http://www.gordonious.com/RC/nuts.bmp
These would be for two 3/4" bulk heads.

http://www.gordonious.com/RC/smallnuts.bmp
These would be for four 1/2" bulk heads.

http://www.gordonious.com/RC/HPIM6850cs.JPG
And here you can hopefully see why I need them.

Sorry keep forgetting HTML doesn't work here. Thanks for the heads up.

Jon

washers don't necessarily have to be round. you can pretty-up (round the corners) of some 1/8" acrylic squares and get a sheet of rubber gasket material to cut gaskets.